CHARGE AIR COOLER (CAC) STRAINER
1. Remove the two M6 x 16 screws securing the strainer to the exhaust
tube.
Cowl support bracket not shown for visual clarity
a - Strainer with poppet valve (not equipped on all models)
b - Port side of exhaust tube
c - Strainer
d - M6 x 16 screws (2)
2. Remove any debris from the strainer.
3. Install the strainer into the exhaust tube.
IMPORTANT:Ensure that the seal is in place on the strainer.
4. Apply Loctite 272 to the M6 x 16 screw threads.
5. Tighten the screws to the specified torque.
Description
Nm lb‑in. lb‑ft
M6 x 16 screws (2) 10 88.5 –
MAINTENANCE
114 eng
To Next Page
Loading...
