2. Remove the M6 x 20 screw securing the elbow to the exhaust tube and
remove the elbow.
a - Starboard side of
exhaust tube
b - Starboard idle relief
muffler
c - Strainer housing
(with two hose
connections, hidden)
d - M6 x 16 screws (2)
e - Elbow
f - M6 x 20 screw
3. Remove the strainer from the elbow. Remove any debris from the
strainer.
4. Install the strainer into the elbow.
a - Strainer
b - Elbow
c - O‑ring
5. Install the elbow and strainer into the strainer housing.
6. Install the elbow into the exhaust tube.
IMPORTANT:Ensure that the O‑ring is in place on the elbow.
7. Apply Loctite 272 to the M6 x 16 and M6 x 20 screw threads.
8. Tighten the screws to the specified torque.
Description
Nm lb‑in. lb‑ft
M6 x 16 screws (2) 10 88.5 –
M6 x 20 screw 10 88.5 –
MAINTENANCE
eng 113
To Next Page
Loading...
