1. Remove the power steering pump cover from the enclosure by releasing
the straps and lifting the cover.
a - Straps (2)
b - Power steering
pump cover
2. Observe the power steering fluid level inside the reservoir. The fluid level
should be between the "MIN" and "MAX" lines on the reservoir.
3. If fluid needs to be added, remove the fill cap from the reservoir and add
Synthetic Power Steering Fluid SAE 0W‑30 until the fluid level is between
the "MIN" and "MAX" lines on the reservoir.
a - Minimum fluid level
b - Maximum fluid level
Description Where Used Part No.
Synthetic Power
Steering Fluid SAE
0W-30
Power steering system 92-858077K01
4. Install the fill cap and install the power steering pump cover. Secure the
power steering pump cover with the straps.
MAINTENANCE
eng 117
To Next Page
Loading...
