4. Disconnect the water‑in‑fuel (WIF) sensor harness.
a - Fuel filter base
b - Fuel filter assembly
c - WIF sensor connection
5. Remove the filter assembly from the base by turning counterclockwise.
6. Empty the fuel filter contents into an approved container and dispose
according to local regulations.
7. Remove the WIF sensor from the end of the fuel filter and retain for reuse.
a. Remove the rubber boot from the bottom of the filter.
b. Remove the WIF sensor by turning counterclockwise.
a - Fuel filter
b - WIF sensor
c - Rubber boot
8. Wipe up any spilled fuel.
Installation
1. Using a hex wrench, remove the plug from the end of the new fuel filter.
MAINTENANCE
98 eng
To Next Page
Loading...
