Mercury Racing 500R - Page 119

IMPORTANT:Replace the fuse with a new fuse with the same amp rating.
a - Fuel injectors ‑ 20‑amp
b - Advanced sound control driver ‑ 5‑amp
c - Propulsion control module (PCM) power ‑ 20‑amp
d - Diagnostics/moving propeller (MP) alert ‑ 5‑amp
e - Ignition coils ‑ 20‑amp
f - Thrust vector module (TVM) power ‑15‑amp
g - Oxygen sensor ‑ 10‑amp
h - Fuel pump ‑ 20‑amp
i - Trim wake ‑ 2‑amp
j - Good fuse
k - Open (blown) fuse
RIG CENTER FUSE PANEL
The rig center fuse panel is equipped with five fuses. Refer to the following
image for identification. Four spare fuses are attached to a harness on the
inside of the rig center. A 30‑amp spare for battery clean power is also included
here.
The electrical wiring circuits on the outboard are protected from overload with
fuses. If a fuse is open, try to locate and correct the cause of the overload. If
the cause is not found, the fuse may open again.
1. Locate the fuse holder on the boat‑mounted rig center. Remove the cover
from the fuse holder.
NOTE:A fuse identification decal is located on the fuse holder cover.
2. Remove the suspected open fuse and look at the silver band inside the
fuse. If the band is broken (open), replace the fuse.
68333
a
b
c
d
e
f
g
h
i
j
k
MAINTENANCE
eng 109 