Description Nm lb‑in. lb‑ft
Oil drain valve 15 132.7 –
IMPORTANT:Overtightening the oil drain valve can damage the oil sump.
8. Add the appropriate amount of engine oil.
OIL CHANGE ON WATER PROCEDURE
1. Tilt the outboard out/up past vertical for approximately one minute to allow
any trapped oil to drain back to the oil sump.
2. Tilt the outboard to a vertical position.
3. Push down on the port side of the service access door to unlock and open
the door.
Push here to unlock
4. Remove the dipstick.
MAINTENANCE
eng 119
To Next Page
Loading...
