100
Chapter 7
Method TWO: Push the WPS Button
Click Start on the screen. Within two minutes, press the WPS button on your device. A
Device-(XX-XX-XX-XX-X X-X X) Connected message should appear on the screen and the
LED should change from blinking to solid on, indicating successful WPS connection.
Note:
XX-XX-XX-XX-XX-XX is the MAC address of your device.
7. 3. 5. Additional Settings
1. Visit http://mwlogin.net, and log in with the password you set for the router.
2. Go to Advanced > Wireless > Additional Settings.
3. Configure the advanced settings of your wireless network and click Save.
Note:
If you are not familiar with the setting items on this page, it’s strongly recommended to keep the provided default values;
otherwise it may result in lower wireless network performance.
To Next Page
Loading...
