Europe—EU Declaration of Conformity and Restrictions
© 2013 Meru Networks, Inc. Regulatory Information xli
Access Points have been designed to operate with the antennas listed below.
Antennas not included in this list are strictly prohibited for use with these devices.
The required antenna impedance is 50 ohms.
AP Antennas with Gain
To reduce potential radio interference to other users, the antenna type and its gain
should be chosen so that the equivalent isotropically radiated power (e.i.r.p.) is not
more than that permitted for successful communication.
Europe—EU Declaration of Conformity and
Restrictions
Note:
Meru Access Points
These devices are restricted to indoor use because they operate in the 5.15 to
5.25 GHz frequency range. Industry Canada requires such products to be used
indoors for the frequency range 5.15 GHz to 5.25 GHz to reduce the potential
for harmful interference to co-channel Mobile Satellite systems.
AP Model Antenna Type Gain (2.4 GHz) Gain (5 GHz)
AP300
Dual-Band Omni-Directional
MN-ANTabg-W
2 dBi 3 dBi
AP300
Dual-Band Omni-Directional
ANT-ABGN-23
2 dBi 3 dBi
AP300
High-Gain Dipole Omni-Directional
ANT-ABGN47O
4.7dBi 4.7dBi
This equipment is marked with either the CE Mark, the alert symbol, and the notified body's
number and can be used throughout the European Community. This mark indicates compliance
with the R&TTE Directive 1999/5/EC and the relevant parts of the following technical speci-
fications.
This equipment is marked with either the CE Mark, the alert symbol, and the notified body's
number and can be used throughout the European Community. This mark indicates compliance
with the R&TTE Directive 1999/5/EC and the relevant parts of the following technical speci-
fications.
To Next Page
Loading...
Need help?
General
