MESI ABPI MD - MAINTENANCE; CLEANING INSTRUCTIONS

34
MAINTENANCE
Read and follow the cleaning instructions carefully.
• Before cleaning the MESI ABPI MD device, disconnect the cus
from the device.
• Use a soft lint-free cloth dampened with a proper cleaning agent
to clean and disinfect the exterior of the MESI ABPI MD device.
• Wipe o all residues of the cleaning solution with a dry cloth.
• Dry the equipment before next use.
• Recommended cleaning agents:
Cleaning – MESI ABPI MD device:
Hydrogen peroxide (3%)
Ethanol (70%)
Isopropanol (70%)
Mild soap (diluted)
Ammonia (diluted)
Sodium hypochlorite bleach (diluted)
6.2 CLEANING INSTRUCTIONS
The MESI ABPI MD device and cus must be carefully cleaned
and disinfected after every use and before use with a dierent
patient. The cus can be reused on the same patient. If the cu is
covered with dust and dirt, this can aect the performance of the
device. Do not use aggressive cleaning agents, volatile liquids or
excessive force when cleaning the device. Don’t dip the cu in
liquids or cleaning agents.
MAINTENANCE
6
If battery operation is desired, the battery should be charged
on a regular basis. The battery capacity is about 100 completed
measurement cycles.
If the battery capacity is significantly decreased after a certain
period of intensive use, the battery is most likely spent and should
be replaced. As the device does not contain any parts that can be
replaced by the user, contact your local distributor or the manufacturer
about battery replacement.
6.1 CHARGING THE BATTERY