METER AQUALAB PAWKIT User Manual

6
OPERATION
4. Press the I button (located on the left) to turn on the instrument.
The instrument will display the last reading taken. This allows the PAWKIT to take a
measurement without anyone attending the instrument throughout the measurement. If
the PAWKIT is already on, proceed to the next step.
I
button
Figure5 I button
5. Press the I button a second time to begin the water activity measurement. The LCD
display resets to 0.00 a
w
.
NOTE: Pressing the I button any time during a measurement restarts the water activity measurement.
Once the measurement process has been started, the PAWKIT begins to display water
activity measurements as well as temperature after 5 s, updating the display every
second thereafter.
During this time the sunburst icon to the right of the water activity value indicates it is
measuring. As it measures, the beams of the sunburst move from left to right.
NOTE: The final water activity measurement is not displayed until the instrument beeps and the sunburst icon
disappears from the screen.
Sunburst and
beams icon
Figure6 Sunburst and beams icon

METER AQUALAB PAWKIT Specifications

General

Brand	METER
Model	AQUALAB PAWKIT
Category	Measuring Instruments
Language	English