What to do if AQUALAB 3 METER Laboratory Equipment indicator light is red?
If the indicator light on your AQUALAB 3 Laboratory Equipment is red, it means the instrument requires calibration. Please contact Customer Support for detailed instructions and assistance with the calibration process.
Why my METER Laboratory Equipment is not reading correctly?
To troubleshoot incorrect readings on your METER Laboratory Equipment, consider the following: * Ensure you are following proper sampling procedures and that your standard solutions haven't expired. * Check if the product you're testing has unique properties that might require special handling. * If you're testing products with volatile compounds, be aware that they can affect water activity readings. Contact Customer Support for guidance. * Inspect the o-ring by removing the sensor block to ensure it is properly seated.
Where to find assigned standards for METER Laboratory Equipment instrument verification?
To find assigned standards for instrument verification, go to skalacontrol.com and select a standard to use in verification of the instrument.
General| Brand | METER |
|---|---|
| Model | AQUALAB 3 |
| Category | Measuring Instruments |
| Language | English |
General introduction to the AQUALAB 3 water activity meter.
Network requirements for the SKALA deployment environment.
Describes how iPad, NEXUS, and AQUALAB 3 connect.
Recommendations to prevent local IP address changes for NEXUS.
Information on using METER data loggers with the system.
Step-by-step guide for the initial setup of the AQUALAB 3 system.
Steps to physically connect the AQUALAB 3 and NEXUS devices.
Steps to connect the iPad and download the SKALA Mobile app.
Process for registering a new company site using the SKALA wizard.
Instructions for registering the first NEXUS device.
Logging into SKALA Mobile for the first time after setup.
Steps to create the first product in the SKALA Mobile app.
Instructions for signing into an existing company account.
Adding more iPads to an existing SKALA system.
Procedures for setting up additional NEXUS devices.
How to add more products for water activity testing.
Selecting market groups, which requires a subscription.
Adding a product for total moisture reading, requires subscription.
Steps for adding a batch for sample preparation.
Guide to setting up and taking readings with AQUALAB 3.
Information on how to take water activity readings.
Information on taking total moisture readings.
Feature for readings to complete after 1 min.
Calculating moisture content using isotherm models.
Performing a linear offset for moisture content calibration.
Detailed specifications of the AQUALAB 3 system.
Description of the sensor block component.
Description of the removable sample drawer.
Explanation of the indicator lights on the drawer knob.
Information regarding the NEXUS device connection.
Describes modes and tests available with subscription.
Explains water activity and moisture content theory.
Validating instrument accuracy through verification tests.
Guidelines for keeping the instrument clean for accuracy.
Common problems and their solutions for AQUALAB 3.
Contact information for customer service and support.
Agreement to METER Group's terms and conditions.
Citation of a relevant study on water activity determination.
To Next Page
