METREL MI 3205 - Transfer Mode; Contrast Selection; Warning Sound; Graph Selection

MI 3205 TeraOhm XA 5kV Main menu
28
4.4.5 Transfer mode
The instrument communication mode can be set.
Keys:
 
Toggles between RS232, USB and Bluetooth.
Note:
 No confirmation is needed to set the desired transfer mode.
4.4.6 Contrast selection
In this selection the contrast of the display can be set.
Keys:
 
Sets contrast value (changes are stored automatically).
Note:
 When using the instrument in a cold environment contrast level should be
increased.
4.4.7 Warning sound
In this selection the Warning sound can be set.
When enabled the Warning sound will
beep when high voltage (≥50 V rms) is present on the input terminals +Rx to –Rx.
Keys:
 
Toggles between YES or NO (changes are stored automatically).
4.4.8 Graph selection
In this selection the graph R(t) logging can be set.
Keys:
 
Toggles between YES or NO (changes are stored automatically).
Note:
 When icon is displayed the internal flash memory is full and graph logging is
disabled.