5.5 Connecting USB devices
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
18
￭￭￭￭￭￭￭￭
915 KF Ti-Touch
1
With the aid of the 6.2151.020 cable, connect the USB connector of
the Ti-Touch (type A) with the USB connector of the printer (type B,
see manual for the printer).
2
Configure the printer in the device manager of the Ti-Touch.
5.5.4 Connecting a balance
If you wish to connect a balance to the Ti-Touch, you will require a USB/
RS-232 adapter (6.2148.050).
The following table offers an overview of the balances that you can use
together with the Ti-Touch and of which cable you will need for connec-
tion to the RS-232 interface:
Balance
Cables
AND ER, FR, FX with RS-232 inter-
face (OP-03)
6.2125.020 + 6.2125.010
Mettler AB, AG, PR (LC-RS9) In the scope of delivery for the
balance
Mettler AM, PM, PE with interface
option 016
or
Mettler AJ, PJ with interface
option 018
6.2146.020 + 6.2125.010
Also from Mettler: ME 47473
adapter and either ME 42500
hand switch or ME 46278 foot
switch
Mettler AT 6.2146.020 + 6.2125.010
Also from Mettler: ME 42500
hand switch or ME 46278 foot
switch
Mettler AX, MX, UMX, PG, AB-S,
PB-S, XP, XS
6.2134.120
Mettler AE with interface option
011 or 012
6.2125.020 + 6.2125.010
Also from Mettler: ME 42500
hand switch or ME 46278 foot
switch
Ohaus Voyager, Explorer, Analyti-
cal Plus
Cable AS017-09 from Ohaus
Precisa balances with RS-232-C
interface
6.2125.080 + 6.2125.010
To Next Page
Loading...
Need help?
General
