Additional requirements for the servo drives concerning the UL approval Page 9
For notes on installation corresponding to EMC, please refer to chapter 7 EMC-compliant
cabling, starting on page 41. The compliance with the limits required by national
regulations is the responsibility of the manufacturer of the machine or system.
The technical data and the connection and installation conditions for the servo drive are
to be found in this product manual and must be met.
DANGER!
The general setup and safety regulations for work on power installations (for example
DIN, VDE, EN, IEC or other national and international regulations) must be complied
with.
Non-compliance may result in death, personal injury or serious property damages.
Without claiming completeness, the following regulations and others apply:
VDE 0100 Erection of power installations with nominal voltages up to 1000 V
EN 1037 Safety of machinery - Prevention of unexpected start-up
EN 60204-1 Safety of machinery - Electrical equipment of machines
Part 1: General requirements
EN 61800-3 Adjustable speed electrical power drive systems
Part 3: EMC requirements and specific test methods
EN 61800-5-1 Adjustable speed electrical power drive systems
Part 5-1: Safety requirements - Electrical, thermal and energy
EN 61800-5-2 Adjustable speed electrical power drive systems
Part 5-2: Safety requirements - Functional
EN ISO 12100 Safety of machinery - General principles for design - Risk assessment and
risk reduction
EN ISO 13849-1 Safety of machinery - Safety-related parts of control systems
Part 1: General principles for design
EN ISO 13849-2 Safety of machinery - Safety-related parts of control systems
Part 2: Validation
More standards to be respected by the user:
EN 574 Safety of machinery - Two-hand control devices
EN 1088 Safety of machinery - Interlocking devices associated with guards
EN ISO 13850 Safety of machinery - Emergency stop
Mounting Instructions „Servo drives ARS 2100 SE“ Version 5.0
To Next Page
Loading...
Need help?
General
