Page 8 Safety notes for electrical drives and controllers
2.3 Danger resulting from misuse
DANGER!
High electrical voltages and high load currents!
Danger to life or serious personal injury from electrical shock!
DANGER!
High electrical voltage caused by wrong connections!
Danger to life or serious personal injury from electrical shock!
DANGER!
Surfaces of device housing may be hot!
Risk of injury! Risk of burning!
DANGER!
Dangerous movements!
Danger to life, serious personal injury or property damage due to unintentional
movements of the motors!
2.4 Safety notes
2.4.1 General safety notes
The servo drive corresponds to IP20 degree of protection as well as pollution degree 2.
Make sure that the environment corresponds to this degree of protection and pollution
degree.
Only use replacement parts and accessories approved by the manufacturer.
The devices must be connected to the mains supply as per EN regulations, so that they
can be cut off the mains supply by means of corresponding separation devices (for
example main switch, contactor, power switch).
The servo drive may be protected using an AC/DC sensitive 300 mA fault current
protection switch, type B (RCD = Residual Current protective Device).
Gold contacts or contacts with a high contact pressure should be used to switch the
control contacts.
Preventive interference rejection measures should be taken for control panels, such as
connecting contactors and relays using RC elements or diodes.
The safety rules and regulations of the country in which the device will be operated must
be complied with.
The environment conditions defined in the product documentation must be kept. Safety-
critical applications are not allowed, unless specifically approved by the manufacturer.
Mounting Instructions „Servo drives ARS 2100 SE“ Version 5.0
To Next Page
Loading...
Need help?
General
