KEY
TO
LUBRICATION DIAGRAM
LUBRICATION DIAGRAM
NOTE.-
The engine oil change periods are those recommended when a multigrade oil is
used. Monograde or single viscosityoil should be changed at 3,000 mile intervals.
DAILY
(1)
ENGINE
. Inspect the oil level, and
top up if necessary with oil to
Ref
. A.
EVERY 3,000
MILES
(5000 Km.)
(2)
STEERING
TIE-ROD
BALL
JOINTS (2 nipples). Give three or
four strokes of a gun filled with
grease to Ref. C.
(3) SWIVEL AXLES
AND
SUS-
PENSION
LOWER
JOINT
S (6
nipples). Give three or four strokes
of a gun filled with grease to
Ref
. C.
(4)
PROPELLER
SHAFT
(2 nipples).
Give three or four strokes of a gun
filled with grease to
Ref
. C.
(5)
HAND
BRAKE
CABLE (1 nip-
pie). Give three or four strokes of
a gun filled with grease to Ref. C.
(6)
HAND
BRAK
E
COMP
EN-
SATOR LEVER (1 nipple). Give
three or four strokes
of
a gun filled
with grease to
Ref
. C.
(7) CARBURETTERS.
Top
up dam-
per assembly reservoirs with oil to
Re
EVERY 6,000
MILES
(10000 Km.)
(8)
ENG
INE. Drain off the old oil
and refill with fresh oil to Ref. A.
(9) GEARBOX. Top up if necessary
to the filler plug level with oil to
Ref. A.
( 10) REAR AXLE. Top up if necessary
to the filler plug level with oil to
Ref. B.
(11) DISTRIBU
TOR
. Lubricate all
parts as necessary.
( 12) OI L FILTER. Wash the bowl in
fuel and fit a new element.
(13) DYNAMO. Add a few drops of
oil to Ref. A through the oil hole
in the commutator end bearing.
EVERY 12,000
MILES
(20000 Km.)
(14)
STEERING-RACK
. Apply the
grease gun filled with oil to Ref. B
to the nipple on the steering rack
and give 10 strokes only.
(15)
WATER
PUMP.
Remove the plug
and add grease to Ref. C ; replace
the plug.
NOTE.
-Oil
and grease references are
to be found on page 68.
To Next Page
Loading...
Need help?
General
