CONTROLS AND I STRUMENTS
Direction indicators
The
flashing direction indicator switch is located on the centre of the fascia
panel. Move the switch to the right or left according to the indicator required. A
warning light on the
fa, cia panel flashes as long as the indicators are in use. The
indicators operate only when the ignition is switched on.
Choke
Pull the knob
out
to its limit when starting from cold, and push it in COITI-
pletely as soon as the engine will
run
witho ut a rich mixture. Never allow the
engine to
run
for long periods with knob pulled out.
BODY DETAIL
Hood
Erecting the hood
Remove the hood from its stowed position (see
pag
e 63).
PI
~,
"
the main
hood
stick in the body sockets with the hinged rail facing
for
ward , th .n with
the peg in line with the slot press the main
hood
stick downwards to compress
the tension springs,
and
lock
both
sides in this position.
Place the
hood
over the open frame work, fit the front rail of the
hoo
d into the
lip of the windshield frame, and secure it with the fastener at each top corner
of the windshield.
Attach the rear hoo d rail to the two slotted fasteners on the tonneau panel
and
the
hood
sides to the body with the turn-buttons
and
fasteners.
Secure the front rail
firmly
into the lip
0/
the windshield
fram e
Turn the lug until the locking
peg is in line with the slot.
Push the hood stick down-
wards and rotate the lug as
indicated to lock the tele-
scopic end
of
the hood stick
in the compressed position
60
Make
certain
that
the front hood rail is still firmly secured in the lip of the
windshield
and
release the telescopic
hood
stick from compression. Turn the
lug to the position shown in the illustration.
Removing the hood
Turn
th~
lug
until
the
lock
ing
p~g
is in
line
with
the s
lo
t.
App
ly
dow
nward
pressure on
both
sides of the main
hood
stick to compress the tension springs
61
To Next Page
Loading...
