4-45
Reversing Radar*
The intelligent reversing radar judges
the distance between rear end of the
vehicle and the obstacle via the
ultrasonic transducer installed on
the rear bumper.
When the vehicle is in the READY
state and the reverse gear is
engaged, the buzzer sounds 1 time,
indicating that the system is normal.
If the buzzer buzzes twice, it
indicates that one sensor fails to
work; if it buzzes 3 times, it indicates
that 2 or more sensors cannot work
normally.
The intelligent reversing radar starts
to work immediately every time you
start the vehicle and shift to reverse
gear.
CAUTION
The reverse sensor can only help
the driver to make judgment. The
driver should always keep
concentrated. MG shoulders no
responsibility for any personal
injury or vehicle damage resulting
from careless driving with great
reliance on the on-board reverse
driving sensor.
When the distance between the
vehicle and the obstacle behind it is
within about 1.5 m~ 1.0 m, the
reverse buzzer sends out alarm
sound at long intervals.
When the distance between the
vehicle and the obstacle behind it is
within about 1.0 m ~ 0.6 m, the
reverse buzzer sends out alarm
sound at short intervals.
When the distance between the
vehicle and the obstacle behind it is
within about 0.6 m ~ 0.4 m, the
reverse buzzer sends out alarm
sound at shorter intervals.
When the distance between the
vehicle and the obstacle behind it is
within about 0.4 m, the reversing
buzzer sends an alarm constantly.
CAUTION
Before reversing, please ensure
that no child or animal is near the
vehicle. When reversing in an area
with complex environments, you'd
better get o for confirmation or
invite someone for observation
outside the vehicle. Do not rely on
the reversing auxiliary device as the
only basis for safety assessment.
4
INSTRUMENT PANEL
C o m f o r t & C o n v e n i e n c e
To Next Page
Loading...
