4-46
and nearer to the vehicle, they
can get out of the eective
detection range, not detected as
a result.
• False alarms may be raised
during uphill or downhill
reversing to remind you to be
more careful in this case.
• Please note that the system is
likely to work abnormally due to
wrong induction under the
following circumstances:
reversing the vehicle on an
uneven road, a road paved with
round stones, an uphill road or
grassland. Interference from
ultrasonic noise, metallic sound
or high pressure gas emission
sound of the same frequency.
Foreign matters are attached to
the sensor surface. Height
change of vehicle rear end under
heavy load. Other detecting
equipment installed within the
eective detection range.
• If any nonstandard radio
communication equipment is
installed on the vehicle, usage of
such equipment (not including
mobile cellphone and audio
system) may aect the function
of this system.
NOTE
!
• To ensure reversing safety and to
leave enough time for the
system to detect, please drive at
a speed of 5 km/h or lower
during reversing.
• Please stop the vehicle
immediately a constant alarm
sound is heard in case that the
vehicle bumps onto the
obstacle behind it.
• Please do not knock the
transducers hard or wash them
directly with a high pressure
water gun, otherwise the
transducers can be damaged.
• Sundries on the transducers
such as snow, mud and water
drops can lead to misoperation.
• Please note that the system is
likely to fail to detect the
following obstacles: those of a
conical shape or acute angle
reflectors. Objects which are
prone to absorb sound wave,
such as cotton and snow. Fine
objects such as iron gauze and
ropes. Obstacles 30 cm below
or protruding obstacles 1m
above the ground. The system
may detect these obstacles
first, but as they become nearer
4
INSTRUMENT PANEL
C o m f o r t & C o n v e n i e n c e
To Next Page
Loading...
