Windshield Wiper
Foreign matters on the windshield
and blade will reduce the
eectiveness of the wiper. If the
blade does not work properly, wipe
the windshield and the blade with
special or neutral washing fluid.
Flush with water thoroughly. If
necessary, repeat the above
operation. Do not wipe the
windshield with corrosive
substances or materials that cannot
be removed from the glass (e.g.
silicone).
The strips have a layer of graphite on
the surface for lubrication and
protection. It should be protected
from excessive wiping and undue
polishing.
Do not start the wiper when the
glass surface is dry. Park the vehicle
in a cool place as far as possible to
prevent exposure to high
temperature, which will accelerate
the aging and deformation of strips.
Remove foreign matters such as bird
droppings, dust and leaves from the
glass surface before starting the
wiper; otherwise, the service life of
strips will be reduced.
5
MAINTENANCE
R e p a i r & M a i n t e n a n c e
5-23
Wiper Repair
The windshield wiper maintenance
switch can be turned on or o in
infotainment cluster under
"S e tt i ngs" - -" Veh icl e"-- " Vehicle
Maintenance"--"Windshield Wiper
Maintenance". After the windshield
wiper maintenance function is
turned on, the wiper will swing to the
maintenance position.
Wiper Blade Replacement
As shown in the figure, adjust the
wiper blade to an angle
perpendicular to the wiper arm, and
then press the blade in the direction
of the arrow to separate the blade
from the wiper arm.
Do the opposite steps to install the
wiper blade.
To Next Page
Loading...
