Michell Instruments XTP601 - User Set-Up Variables (Passcode Required); Figure 16 User Set-Up Variables Page

XTP601 User’s Manual
14 97313 Issue 5, May 2018
OPERATION
2.7 User Set-Up Variables (Passcode Required)
In order to change any settings on the User Menu pages, the user must enter a passcode.
There is also a separate passcode for service engineers to allow factory setting changes.
To access the User Menu press the
ENTER button from the Main Page to call up a
passcode prompt. Use the
Up () and Down () buttons and press ENTER after each
value.
The User Passcode is:
1919
SETTINGS
HMI
RESET
OUTPUTS
EXT COMP.
EXT SENS.
CLOCK
FIELD CAL
Figure 16 User Set-Up Variables Page
Use the Up () and Down () buttons to select the sub-menu required. Then press
the
ENTER button. This will give access to one of the following pages.