Section 1.0 - Product Summary
SW800 is a universal, non-handed, electro-mechanical swing door operator which provides powered door opening upon
activation. The unit is designed to facilitate barrier free access into and within building through swing doors.
When properly installed and programmed, this product complies with ANSI/BHMA A156.19 Standard for Power Assist
and Low Energy Power Operated Swinging Doors.
SW800 features enable the continuous automation of pedestrian doors while offering Low energy barrier-free access.
(THE SW800 IS) Designed to achieve the highest degree of safety while offering a long service life.
It is the responsibility of the installer and installation company to certify that the final completed operator is installed
in accordance with local building codes, applicable laws, and ANSI 156.19 standards governing this product.
Opening
When an open signal is received by the control unit, the door is opened at the factory set or pre-adjust opening speed.
Before the door is fully open, it will begin its back check, slowing automatically to low speed. The motor stops when the
selected full open angle has been reached. The open position is held by the motor.
In case the door encounters an obstruction during the opening cycle, once the maximum current limit is reached for at
least two (2) seconds, the door opening is then cancelled.
Closing
When the activation time has elapsed, the operator will close the door automatically using spring force and motor
power. The door will slow to latch speed before it reaches the full closed position. The door is kept closed by spring
power.
Power Failure
During power failure, the operator acts as a manual door closer with controlled closing speed.
SW800 can be surface mounted or overhead concealed mounted on either side of the door header for left, right, pull, or
push applications. It is suitable for either single or double door opening being either hinged or center hung mounted.
ALL PRODUCT, PRODUCT SPECIFICATIONS AND DATA ARE SUBJECT TO CHANGE
WITHOUT NOTICE TO IMPROVE RELIABILITY, FUNCTION OR DESIGN OR
OTHERWISE. ... It is the customer's responsibility to validate that a particular product with
the properties described in the product specification is suitable for use in a particular
application.
To Next Page
Loading...