Micom SW800 - Basic Settings Table Describing the Controls Functions, Settings, Values and Defaults

SW800 Installation Manual
23
Basic Settings Table describing the Controls Functions, Settings, Values and
Defaults
All values and settings must comply with ANSI/BHMA A156.19 Standard for Power Assist and Low Energy Power
Operated Swing Doors.
No.
FUNCTION DESCRIPTION
SETTING
VALUE
DEFAULT
1
OPENING SPEED
Door opening speed from full closed to back
check position
5 to 20
5 sec = slowest
20 sec = fastest
10
2
BACK CHECK SPEED
Door speed at final section of opening
1 to 5
1 sec = slowest
5 sec = fastest
3
3
SAFETY SPEED
Slow speed (crawl) or stop (hold) when
Safety1 is active
2 steps
HOLD/CRAWL
HOLD
4
CLOSING SPEED
Door closing speed from full open to latch
position
1 to 15
1 sec = slowest
15 sec = fastest
5
5
LATCH SPEED
Door speed at final section of closing
1 to 5
1 sec = slowest
5 sec = fastest
1
6
CURRENT LIMIT
Obstruction detection
1 to 20
1 sec = more sensitive
20 sec = less sensitive
10
7
ACTIVATION TIME
Time begins at activation signal ON
1 to 60
1 sec = minimum
60 sec = maximum
5
8
HOLD ON MANUAL OPEN
Door held open when pushed by hand. Not
active with push & go
2 options
A = No
B = 5 steps (1-5 sec)
No
9
ELECTRIC DOOR STOP
Setting stop position by encoder
2 options
Y = Yes
N = No
Yes
10
E-LOCK
Strike or Electromagnetic Lock
2 options
Y = Yes
N = No
No
11
E-LOCK DELAY
Time before E-Lock will release
18 steps:
0.2 sec to 2.0 sec
0.2 sec = minimum
2.0 sec = maximum
1.0
12
LATCH POSITION
Position at which final section of closing begins
15 steps:
2% to 30%
2% = minimum
30% = maximum
10
13
BACK CHECK POSITION
Position at which final section of opening
begins
15 steps:
70%-98%
70% = maximum
98% = minimum
80
14
PUSH & GO
2 options
Y = Yes
N = No
No
15
PUSH & GO ACTIVE TIME
Time door is pushed open before activation
30 steps
1 sec = minimum
30 sec = maximum
3