Section 4.0 - Pre-Installation Information
4.1 Safety Precautions
• Only trained technicians are authorized to carry out these operations.
• Ensure all power is OFF to the unit before performing any work or maintenance.
• Do not climb or put weight on any door or header parts.
• Do not let children play with the operator or the electrical board.
• Keep remote controls away from children.
To avoid bodily injury, material damage, and malfunction of the product, the instructions contained in this manual must
be strictly observed during installation, adjustment, repair, and service.
Training is needed to carry out these tasks safety.
4.2 Compliance Codes and Standards
It is the responsibility of the final installer and/or installation company to certify that the final completed operator is
installed in accordance with ANSI/BHMA A156.19 Standard for Power. Assist and Low Energy Power Operated Swing
Doors, local building codes and applicable laws.
Be sure to complete the site inspection and acceptance test before taking the door into operation.
• All wiring must conform to standard wiring practice in accordance with national and local wiring codes.
• Door must swing feely through the entire opening and closing cycle before beginning of installation.
• Incorrectly installed or improperly adjusted door operators can cause property damage or personal injury.
• All dimensions are given in inches (millimeters), unless otherwise noted.
• Before installation, verify door frame is properly reinforced and is well anchored in the wall.
• Concealed electrical conduit and concealed switch or sensor wires should be pulled to the frame before proceeding.
4.3 Electrical
The 115+/-5 VAC supply lines are connected into the Green Connector block located to the left hand side of the control
unit. Words clearly indicate its correct wiring. The ground wire is also connected into the Green Connector block.
The control board settings have been pre-set prior to shipment. It will be necessary for the door operator to be
functional while adjustments and settings are made. Please follow these instructions for a successful installation.
To Next Page
Loading...