Micro Motion CDM100P - Page 176

Sample calibration certificate: K format, US unitsFigure A-3:
DENSITY CALIBRATION CERTIFICATE
CDM100PA18MBAZ00EANZZ 2012.10031Model Code:
Customer Tag:
Serial No:
Calibration Date:
Pressure Test:
2013-07-01 11:05:22
Calibration ID: 1.29825731
3263 psi(g)
7835|7845 "K" Coefficients (US Units)
K0 =
368
Density Calibration Coefficients @68°F
Temperature Compensation Coefficients:
Pressure Compensation Coefficients:
K18 = 371
K19 =
372
K20A=
373
Calibrated Range = 0.3-1.3 g/cm³ (300-1300 kg/m³)
K1 = 369
K2 = 370
K20B=
K21A=
K21B=
Range: 1-580 psi(g) Range: 435-1015 psi(g) Range: 870-1450 psi(g) Range: 1450-2175 psi(g)
373 373 373
0.0 0.0 0.0 0.0
0.0 0.0 0.0 0.0
0.0 0.0 0.0 0.0
Time Period, TP secμ
Density (g/cm³)
Density Calibration Data:
5065.20540.00097
5587.31510.79882
5857.00311.24079
Performance Check:
Error (g/cm³)Density (g/cm³)
0.99822 -0.00008
Known Density Verification Data:
765.1Verification Time Period (Air) @ 68°F = μsec
CALIBRATED BY:
D = Density (uncompensated)
TP = Time period
P= Pressure
Definitions:
°F
g/cm³
g/cm³Dt = Density (Temperature compensated)
Dp = Density (Pressure & Temperature compensated) g/cm³
µsec
T = Temperature
psi(g)
Form Rev: 1
2013-08-29 13:55:06Printed Page 3 of 3
All equipment used for this calibration is calibrated at routine intervals against
standards that are traceable to the International System of Units (SI).
Emerson Process Management Micro Motion, Inc. 7070 Winchester Circle, Boulder, CO 80301
SAMPLE
Calibration certificate
170 Micro Motion
®
Compact Density Meters (CDM)