Micro Motion CDM100P - Page 175

Sample calibration certificate: K format, SI unitsFigure A-2:
DENSITY CALIBRATION CERTIFICATE
CDM100PA18MBAZ00EANZZ 2012.10031Model Code:
Customer Tag:
Serial No:
Calibration Date:
Pressure Test:
2013-07-01 11:05:22
225 bar(g)
Calibration ID: 1.29825731
7835|7845 "K" Coefficients (SI Units)
K0 =
-3.675285E+000
Density Calibration Coefficients @20°C
Temperature Compensation Coefficients:
Pressure Compensation Coefficients:
K18 = -3.154066E-004
K19 =
-9.992198E-004
K20A=
1.238665E-004
Calibrated Range = 300-1300 kg/m³ (0.3-1.300 g/cm³)
K1 = 0
K2 = 1.432987E-007
K20B=
K21A=
K21B=
Range: 1-41 bar(a) Range: 31-71 bar(a) Range: 61-101 bar(a) Range: 101-151 bar(a)
1.238665E-004 1.238665E-004 1.238665E-004
0.0 0.0 0.0 0.0
0.0 0.0 0.0 0.0
0.0 0.0 0.0 0.0
Time Period, TP secμ
Density (kg/m³)
Density Calibration Data:
5065.20540.97
5587.3151798.82
5857.00311240.79
Performance Check:
Error (kg/m³)Density (kg/m³)
998.22 -0.08
Known Density Verification Data:
765.1Verification Time Period (Air) @ 20°C = μsec
CALIBRATED BY:
D = Density (uncompensated)
TP = Time period
P= Pressure
Definitions:
°C
kg/m³
kg/m³Dt = Density (Temperature compensated)
Dp = Density (Pressure & Temperature compensated) kg/m³
µsec
T = Temperature
bar(a)
Form Rev: 1
2013-08-29 13:55:05Printed Page 2 of 3
All equipment used for this calibration is calibrated at routine intervals against
standards that are traceable to the International System of Units (SI).
Emerson Process Management Micro Motion, Inc. 7070 Winchester Circle, Boulder, CO 80301
SAMPLE
Calibration certificate
Configuration and Use Manual 169