MicroNet SP676C - Page 39

39
SNMP Setup [enable|disable]
Description:
Activate or deactivate the SNMP.
[enable|disable]: Enable/disable SNMP (default: Show SNMP mode).
SNMP Trap [<IP Address>]
Description:
Set or show SNMP traps destination.
<IP Address>: IP address to send traps to. (default: Show trap configuration)
Ratelimit Commands
Commands at Storm Control level:
Ratelimit Configuration
Ratelimit Setup <traffic type > <option>
Ratelimit Egress [<portlist>] [enable|disable] [<rate>]
Ratelimit Ingress[<portlist>] [enable|disable] [<rate>]
[<portlist>] :Port list (default: All ports).
[enable|disable] :Enable or disable.
[<rate>] :Set leaky bucket rate in Kbit/s[128/256/512/1024/2048/3072K]
(default: Show rate).
Ratelimit Configuration
Description:
Show the Storm Control setting.
Ratelimit Setup <traffic type > <option>
Description:
Set or show the storm control configuration. The allowed frame rates for
ICMP frames, learn frames, multicasts, broadcasts and flooded unicasts are
controlled using a central storm controller.
[<traffic type>] : Storm controller to set. Can be one of:
[ICMP|Broadcast|Multicast]
(default: Show all).
[enable|disable] : Enable or disable specified storm controller.
[<rate>] : Frame rate in kiloframes
Allowed values are 1k, 2k, 4k, 8k, 16k, 32k, 64k,