DOC 6501_Release V
ATS-6501 Users Guide
130
[local_tdc] -5.222222222222222e-09 Offset Measurement
[remote_device] 6511 Remote Device Type
[remote_network_status] 00 00 00 00 00 00 00 00 Future Use
[serial_number] 164233 S/N of downstream device
[unit_status] 00 00 00 00 00 Future use.
[input_status] Fiber Transceiver status
[signal_detect] true Signal return Detected
[tx_fault] false Transmitter Fault
[xcvr_present] true SFP installed on Port.
[status] good Current port status
[2-4] [Port 2-4]
[power] enabled Enabled/Disabled
[type] 4372A-T Card Type
[6] Legacy Fiber Card
[ports] Port Status [1-4]
[1]
[status] good
[2]
[status] good
[3]
[status] good
[4]
[status] good
[power] enabled Enabled/Disabled
[type] 4372A Card type
[warmstartable] true Unit has enough data to warmstart.
[power] Power Supply Status
[numsupplies] 2 # of installed supplies
[supplies]
[1] Left Power Supply
[status] good Current status
[type] 4385A Power supply type
[2] Right Power Supply
[status] good
[type] 4385A
[temperature] 37 Current internal temperature
[health] Health Status
[clock_freq_step] Monitored alarm condition
[active] false Alarm active = true
[occurrences] 0 # of alarm occurances since start up
[clock_phase_step] Applies to each alarm type down through TCXO
[active] false
[occurrences] 0
[clock_starvation]
[active] false
[occurrences] 0
[clock_steer]
[active] false
[occurrences] 0
[clock_wander]
[active] false
[occurrences] 0
[fan]
[1]
[active] false
[occurrences] 0
[2]
[active] false
[occurrences] 0
[firmware_version_mismatch]
[active] false
To Next Page
