Microsemi ATS-6501B T-Flex - Status Port (1900); Average TIC Data Port (2100)

DOC 6501_Release V
ATS-6501 Users Guide
68
[clock] info
[cpld4370] info
[gps] info
[kas2] info
[lnsrawstate] info
[software] info
[tagps] info
[timecode] info
[tsc4370] info
[tsgather] info
[warmstart] info
[OK] 2013-08-07T20:35:22Z
To change the settings use the diag command then specify which subsystem you would like to
change (gps, kas2, clock, tagps, timecode, tsc4370), then specify which message types (error,
info, or debug) you would like to see for that subsystem. Example – if you want to look at the
debug messages for the GPS use the diag gps debug command. You can verify this by using the
settings diaglog command.
ATS-6501>diag gps debug
[OK] 2013-08-07T20:36:07Z
ATS-6501>settings diaglog
[clock] info
[cpld4370] info
[gps] debug
[kas2] info
[lnsrawstate] info
[software] info
[tagps] info
[timecode] info
[tsc4370] info
[tsgather] info
[warmstart] info
[OK] 2013-08-07T20:36:24Z
Users can modify these settings as needed and are able to save these settings to the default start
up if desired by typing save. These settings can also be saved to a different configuration file if
desired by typing save and providing a configuration filename. tagps is included to enable
customer data collection for Time Augmented GPS.
3.4.3.4 Status Port (1900)
This port provides users with real time system status updates. As the fields that are displayed
using the config, settings, status, and network commands are updated internally they are
forwarded to this port in real time. Users wanting to display system parameters, measurements,
and/or alarms in real time are able to use the data provided by the status port to update their
displays in real time. See Appendix C for an example of the data provided by the status port.
3.4.3.5 Average TIC Data Port (2100)
This port provides users with average measurement results from each of the 4393A TIC Cards
installed in the ATS-6501. The measurements will only be available for the port(s) on the card(s)