Microsemi ATS-6501B T-Flex - Appendix B Status Command Fields

DOC 6501_Release V
ATS-6501 Users Guide
129
Appendix B Status Command Fields
This section provides information on the results from the status command
ATS-6501>status
[alarm] no alarm No active alarms
[gps]
[mode]
[desc] tracking Current GPS Tracking Mode
[value] 4 Value to indicate current tracking status.
[model] GPS Receiver information
[hw_version] OEMV3G-4.00-X2T Hardware version
[name] L12LV Model Name
[serial_number] DAB08210167 Serial #
[sw_version] 3.400 Current firmware version
[position] Position Data
[alt] 1.957604000000000e+02 Altitude in meters
[fixed] true Position Type
[lat] 3.992277932811000e+01 Current latitude
[lon] -7.758567672868000e+01 Current longitude
[satellite] Sateliite Information
[number] 8 # of satellites being tracked
[signal] Signal information
[avg] 4.669162750244141e+01 Average C/N
[desc] Good Signal Description
[enum] 2 Value to indicated signal description
[freq] dual Single/Dual frequency
[max] 5.058900070190430e+01 Maximum C/N value
[min] 4.158399963378906e+01 Minimum C/N value
[hardware] Hardware Info
[fan] Fan Status
[1] true Fan 1 True – Good, False - Bad
[2] true Fan 2
[mainboard] Mainboard Info
[EUID] 00:30:96:02:00:00:00:98 Electronic Unit ID
[serialnum] SP00235 Unit Serial #
[type] 4370A-140 Mainboard model
[outputs] Output Status
[enabled] true Enabled/Disabled
[slots] Card Status
[1] Slot [1-6]
[ports] Port status [1-4]
[1]
[status] good Good/Bad/Disabled
[2]
[status] good
[3]
[status] good
[4]
[status] good
[power] enabled Enabled/Disabled
[type] 4394A Card Type
[2-4] Same for other cards, reports empty if no card in slot
[5] Two-Way Fiber Card
[ports] Port [1-4] status
[1]
[fiber_status] Device Status