DOC 6501_Release V
ATS-6501 Users Guide
30
[3]
[status] good
[4]
[status] good
[power] enabled
[type] 4395B-5
[OK] 2013-08-05T16:37:43Z
2.4.2.7 4395A-1 / 4395B-1 1MHz Card
No programming is required for these modules. These modules will also work in any of the 6
card slots. To verify these cards are working properly use the status hardware:outputs:slots:N
command (N = slot number) to obtain the current status for a particular card.
ATS-6501>status hardware:outputs:slots:5
[ports]
[1]
[status] good
[2]
[status] good
[3]
[status] good
[4]
[status] good
[power] enabled
[type] 4395B-1
[OK] 2013-08-05T16:37:43Z
2.4.2.8 4387A, 4387A-6V, and 4387A-1V (Modulated IRIG/NASA36)
This module provides four Amplitude Modulated (AM) IRIG Outputs or the NASA36 Serial
Time Code. Valid AM IRIG Codes are A (130, 133, 137), B (120, 123, 127), E (111, 112, 121),
G (141, 142, 147), and H (111, 112, 121, 122, 127). The default time code is B120. The 4387A-
6V module provides 6 Vpp output signals.
• IRIG: To set the IRIG Code for the individual ports use the irig command:
ATS-6501> irig [slot#] [port#] [Code A-H] [Code Format <NNN>] [epoch]
The following example sets the IRIG Code for Slot 5, Port 3 to G 141 and the epoch off
(epoch is off by default). The epoch option is not required to properly execute this
command and can be left off the command line.
ATS-6501>irig 5 3 G 141 0
OK
[OK] 2013-08-05T16:35:12Z
The system will generate an error message if the operator attempts to enter an
unsupported or invalid code.
To verify the settings use the settings hardware:slots:N command (where N=Slot #) to
obtain the current settings for a particular card.
ATS-6501>settings hardware:slots:5
[tsc4387]
To Next Page
Loading...