DOC 6501_Release V
ATS-6501 Users Guide
34
[signal_detect] true
[tx_fault] false
[xcvr_present] true
[status] good
[2]
[fiber_status]
[local_tdc] 1.463137254900000e-08
[packet_number] 0
[remote_device] 6511
[serial_number] 163916
[input_status]
[signal_detect] true
[tx_fault] false
[xcvr_present] true
[status] good
[3]
[input_status]
[signal_detect] false
[tx_fault] false
[xcvr_present] true
[status] good
[4]
[fiber_status]
[local_tdc] 1.443529411800000e-08
[packet_number] 2
[remote_device] 6511
[serial_number] 154825
[input_status]
[signal_detect] true
[tx_fault] false
[xcvr_present] true
[status] good
[power] enabled
[type] 4372A-T
[OK] 2013-08-05T16:31:14Z
Note: Two-way over fiber is not supported prior to Version 4 of the software; if you are running
an earlier version of the software on the ATS-6501 and you install at 4372A-T card the system
will display an alarm condition. The hardware status will show the slot has a 4372A-T card
installed and the card has a “hardware error” and the downstream devices on that card will not be
able to sync to that fiber input.
2.4.2.12 4393A Time Interval Counter (TIC) Card
This module has four input ports that can be used to measure the time interval between the
internal 1PPS and up to four external sources and will work in any of the 6 card slots. The default
averaging period for the measurements is 10 seconds and can be adjusted using the ptdavg
command. Valid settings are 1, 10, 20, 60, 300 seconds. This setting is global and applies to all
of the TIC Cards installed in the ATS-6501.
ptdavg 20
OK
[OK] 2013-08-05T16:42:56Z
To verify the averaging interval use the settings ptd_port command
ATS-6501>settings ptd_port
[averaging_interval] 20
To Next Page
