Microsemi ATS-6501B T-Flex - 4372 A-T Fiber Output Card (Two-Way)

DOC 6501_Release V
ATS-6501 Users Guide
33
To verify the output card settings use the settings hardware:slots:N command where N is the slot
# where the 4374A card is installed.
ATS-6501>settings hardware:slots:3
[tsc4374]
[ports]
[1]
[enabled] true
[mode] 0
[2]
[enabled] true
[mode] 1
[3]
[enabled] true
[mode] 2
[4]
[enabled] true
[mode] 3
[OK] 2016-10-03T17:01:52Z
To verify these cards are working properly use the status hardware:outputs:slots:N command (N
= slot number) to obtain the current status for a particular card.
ATS-6501>status hardware:outputs:slots:3
[ports]
[1]
[status] good
[2]
[status] good
[3]
[status] good
[4]
[status] good
[power] enabled
[type] 4374A
[OK] 2016-10-03T16:57:24Z
2.4.2.11 4372A-T Fiber Output Card (Two-Way)
No programming is required for this module. This module will work in any of the 6 card slots.
To verify the card is working properly use the status hardware:outputs:slots:N command (N=Slot
#) to obtain the current status for a particular card.
ATS-6501>status hardware:outputs:slots:5
[comm_errors]
[4340A] 0
[6511]
[local] 0
[remote] 0
[ports]
[1]
[fiber_status]
[local_tdc] 1.541568627500000e-08
[packet_number] 2486
[remote_device] 6511
[serial_number] 163920
[input_status]