Microsemi ATS-6501B T-Flex - Real Time Data Port (1135); Command Port (1700)

DOC 6501_Release V
ATS-6501 Users Guide
64
3.4.3.1 Real Time Data Port (1135)
Certain applications require that GPS data be retrieved in a timely manner. For this purpose, Port
1135 may be configured to provide real-time data output. Users can specify which logs are
output and users may request any of the ASCII logs specified in the user manual for the Novatel
OEMV receiver (http://www.novatel.com/support/docupdates.htm#oemv). See the log command.
3.4.3.2 Command Port (1700)
System commands can be issued to the ATS-6501 via the command port. These commands
provide a limited set of operations to be used for remote control of the system. Typically, a
remote monitoring station may record an error that indicates user intervention is required. The
remote monitoring station would then be able to access the command port via the Ethernet and
issue the commands required for recovering from the error. The following list provides a short
description of each command.
Note: All commands are in lowercase and the commands are case sensitive.
Command Description
Basic Commands
help, h or ? <command> Display help for a command or list all commands. Proper format
is to proceed the command with help, h, or ? help <command>
quit Closes the command connection and terminates the telnet
connection.
Status Commands
show Shows the current system factory (config), user configuration
(settings), network (network), and system status (status) values.
This command is the equivalent of sending these 4 commands at
the same time.
status Shows the values of all runtime status variables
alarm Shows the current alarm state
alarms Shows active alarms
config Shows unit configuration parameters
network Show network interface configuration.
Note:
These settings do
not apply if the mode=DHCP.
syslog Dump the system log file.
diag Adjust diagnostic logging levels.
diag_port Switch to the diagnostic port (1800).
ptdavg_port Switches the command port display to port 2100 to view the
average measurement results.
ptdraw_port Switches the command port display to port 2101 to view the raw
measurements every second.
status_port Switch to the status port (1900)
Settings
settings Shows the current user control/configuration settings.
diff Displays any difference between the current system settings and
the saved user configuration file.
load Restore system configuration settings from a file on the disk
save Save current configuration settings to disk. save <filename>.
Default = <default>