EasyManua.ls Logo

Microsemi ATS-6501B T-Flex - Page 141

Microsemi ATS-6501B T-Flex
222 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
DOC 6501_Release V
ATS-6501 Users Guide
133
[32] 7.604166667000000e-09
[33] 1.306122449000000e-08
[34] 7.553191489000000e-09
[time] 2013-07-18-18:09:24 Time report was printed
[unit] Unit status
[network]
[MAC] 00:30:96:00:00:98 Units MAC Address
[broadcast] 192.168.150.255 Broadcast IP
[default_gateway] 192.168.150.1 Gateway IP
[ip] 192.168.150.61 Units IP Address
[netmask] 255.255.255.0 Current Netmask
[serial_number] SP00235 Units S/N
[start] 2013-07-18-12:50 Start Up Time.
[uptime] 5 hours, 18 minutes, 35 seconds Length of time the application has run
[ver] tflex-5-1-0 Software version
[OK] 2013-08-08T15:30:43Z Time the status command was executed.
4391 Code Generator Status
This information only applies if the TSC4391 card is installed in the unit.
memblocks:[1-4]:state: State of the memory block. The state will be “unassigned”,
“uninitialized”, “downloading”, “validating”, “ready”, “invalid file”, “i/o error”, or “internal
error”. Memory blocks having a state of “i/o error” will cause file download retries to occur,
while blocks having a state of “invalid file” will not cause file download retries. The “internal
error” state indicates a system error of some type. Bit generation from memory blocks may occur
only when the memory block state is “ready”.
[clocks]
[1]
[bit_rate] 7.999999999999830e+06 Achieved bit rate for clock 1
[delay] 0.000000000000000e+00 Achieved delay for clock 1
[enabled] true Actual state of the clock.
[2]
[bit_rate] 3.999999999999915e+06
[delay] 0.000000000000000e+00
[enabled] true
[crc_engine_busy] false State of the firmware CRC calculation engine
[memblocks]
[1] Data available on active/loaded blocks
[bit_count] 8000000 Bit count of the memory block
[crc16]
[value] 0xAB52 CRC calculation results
[word_address] 0x00000000
[word_count] 0x0007A29C
[state] ready See above.
[state_text] n/a
[2] Blocks 2-4 reflect inactive memory block status
[state] unassigned
[state_text] n/a
[3]
[state] unassigned
[state_text] n/a
[4]
[state] unassigned
[state_text] n/a
[ports]
[1]
[alarm_text] n/a
[status] good

Table of Contents

Related product manuals