Microsemi ATS-6501B T-Flex - Page 92

DOC 6501_Release V
ATS-6501 Users Guide
84
[remote_network_status] 00 00 00 00 00 00 00 00
[serial_number] 164233
[unit_status] 00 00 00 00 00
[input_status]
[signal_detect] true
[tx_fault] false
[xcvr_present] true
[status] good
[2]
[fiber_status]
[local_tdc] 3.000000000000000e-08
[remote_device] 6511
[remote_network_status] 00 00 00 00 00 00 00 00
[serial_number] 164235
[unit_status] 00 00 00 00 00
[input_status]
[signal_detect] true
[tx_fault] false
[xcvr_present] true
[status] good
[3]
[fiber_status]
[local_tdc] 3.040816326530612e-08
[remote_device] 6511
[remote_network_status] 00 00 00 00 00 00 00 00
[serial_number] 164227
[unit_status] 00 00 00 00 00
[input_status]
[signal_detect] true
[tx_fault] false
[xcvr_present] true
[status] good
[4]
[fiber_status]
[local_tdc] 3.000000000000000e-08
[remote_device] 6511
[remote_network_status] 00 00 00 00 00 00 00 00
[serial_number] 161850
[unit_status] 00 00 00 00 00
[input_status]
[signal_detect] true
[tx_fault] false
[xcvr_present] true
[status] good
[power] enabled
[type] 4372A-T
Note: Slots [1-6] will display information based on which slots have cards in them and what
type of cards are installed. If a card is not installed the type will be empty. Slot 6 in this
example shows the typical information provided by the 4372A-T card.
G. The warmstart table may be true or false. If the unit has been running for under an hour
this may be false.
[warmstartable] true Filter has enough data to warm start the system during a restart/reboot.
H. The power supply status should show both power supplies operating normally. The slots
fields should show which cards are installed in each slot (or empty if no card is present),
the port status for all four outputs are good (=1) and power is enabled.