Midland DBR2500 - CTCSS Scan; DCS Scan; Frequency and Channel Scan

Model DBR2500
page 19
midlandusa.com
CTCSS Scan
In channel or VFO mode, press and release [FUNC] to switch function group, choose the [P:X]
button dened as CDT function. press and release this button to enter CTCSS code setting.
When the LCD displays CTC, press and hold this button to enter CTCSS scan� Turn channel
knob or press microphone [UP]/[DOWN] button to change scan direction. Once it nds a
matching CTCSS signal, it will stop for 5 seconds, then scan again, press and release any
button to exit CTCSS scan�
DCS Scan
In channel or VFO mode, press and release the [FUNC] button to switch function group, choose
the [P:X] button dened as CDT function. Press and release this button to enter DCS code
setting� When the LCD displays DCS, press and hold this button to enter DCS scan, turn the
channel knob or press the microphone [UP]/[DOWN] button to change scan direction� Once it
nds nd a matching DCS signal, it will stop for 5 seconds then scan again, press any button to
exit DCS scan�
Frequency/Channel Scan
Frequency Scan
In frequency (VFO) mode, this function is designed to monitor signal of all frequency
points under each step size�
1� In VFO mode, press and release the [FUNC] button to switch the function group, choose
the [P:X] button dened as SCN function.
2. Press and release the [P:X] button dened as SCN function to start frequency scan, the
LCD displays “S”�
3� Turn channel knob or press microphone [UP]/[DOWN] button to change scan direction�
4� Turn channel knob or press any button except the microphone [UP]/[DOWN] button to exit�
Channel Scan
In channel mode, this function is designed to monitor the signal of all channels�
1� In channel mode, press [FUNC] button to switch function group, choose the [P:X] button
dened as SCN function.
2. Press and release the [P:X] button dened as SCN function to start channel scan, the LCD
displays: “S”�
3� Turn the channel knob or press microphone [UP]/[DOWN] button to change scan direction�
4� Turn the channel knob or press any button except the microphone [UP]/[DOWN] button to
exit�
Scan Skip
In channel mode, press [FUNC] button to switch function group, choose the [P:X] button dened
as SCN function� Hold this button to add into or delete from the scan list�
1� When the LCD displays:S, the current channel is in the scan list�
2� When LCD does not displays:S, the current channel is not in the scan list�