Setting a Password
If this function is enabled, the correct password must be input in order to turn on the DBR2500�
Access the programming software (page 30) to set or change the password� The DBR2500
comes default from the factory with the password set to 123456�
1� Enter the FUNCTION MENU list, choose the No�06 function
2� Press the [PUSH] button, the menu value in the LCD turns to green
3� Turn the channel knob to choose the desired setting
ON: Turn on password function
OFF: Turn o password function
4� Press the [PUSH] button or [P3] button to store setting and exit
Scan Dwell Time Setup
1� Enter the FUNCTION MENU list, choose the No�07 function
2� Press the [PUSH] button, the menu value in the LCD turns to green
3� Turn the channel knob to choose the desired setting
TO: it will pause for the preset pause time when scanning a matching signal, then resume
scaning
CO: it pauses once when scanning for a matching signal, and resumes scanning when the
signal disappears
SE: it stops once scanning receives a matching signal
4� Press the [PUSH] button or [P3] button to store the setting and exit
Scan Pause Time Setup
1� Enter the FUNCTION MENU list, choose the No�08 function
2� Press the [PUSH] button, the menu value in the LCD turns to green
3� Turn the channel knob to choose the desired setting
5S : It pauses 5s while scanning for a matching signal, then resumes scanning
10S : It pauses 10s while scanning for a matching signal, then resumes scanning
15S : It pauses 15s while scanning for a matching signal, then resumes scanning
4� Press the [PUSH] button or [P3] button to store the setting and exit
AOP (Automatic Power On) Setup
When AOP is turned o, the radio requires the to be pressed to power on the radio
1� Enter the FUNCTION MENU list, choose the No�09 function
2� Press the [PUSH] button, the menu value in the LCD turns to green
3� Turn the channel knob to choose the desired setting
ON : Enable AOP function
OFF: Power o by manual
4� Press the [PUSH] button or [P3] button to store the setting and exit
To Next Page
Loading...
Need help?
General