English-73
004-1055-00
TP210 Rev. A
© 2013 Midmark Corp. | 60 Vista Drive Versailles, OH 45380 USA | 1-800-643-6275 | 1-937-526-3662 |
[Revised: mo/dd/yr]
Base Shrouds / Cladding
Raising (w/ bungee cord)
Standard Base
Rotational Base
Bungee Cord
Bungee Cord
Step 2: Stretch bungee cord across top
of base column (under seat).
Note: It may be necessary to run Tilt Up function to
route bungee cord under seat section.
Step 1: Remove two screws
from inner shrouds.
Step 3: Lift shrouds, then attach bungee cord
hooks under shrouds on both sides.
Step 1: Remove four screws
from inner shrouds.
WARNING
Always disconnect table from power source before removing
any covers. Failure to do so may result in personal injury.
Troubleshooting Chart .................................... 2
Error Code Chart .......................................... 15
Troubleshooting Chart .................................... 2
Error Code Chart .......................................... 15
To Next Page
Loading...