Problem solving guide
110
Many malfunctions and faults that can occur in daily operation can be easily
remedied. You can save time and money in many cases, as you do not need to call
the Miele Customer Service Department.
Information to help you rectify faults yourself can be found at www.miele.com/ser-
vice.
The following tables are designed to help you to find the cause of a malfunction or
a fault and to resolve it.
This section only lists faults that you can remedy yourself. All other faults are
shown in Fault F.
Technical problems
Problem Cause and remedy
The display remains
dark after the sensor
control has been
pressed long enough.
The machine is not plugged in.
Insert the plug and switch on at the socket.
The mains fuse has tripped.
Reset the mains fuse (see data plate for minimum
protection rating).
If the mains fuse trips again, contact the Miele
Customer Service Department.
The sensor control
does not respond or
only responds once it
has been touched sev-
eral times.
Energy management: the door was opened or closed
shortly before the sensor control was touched. As
a result, the dishwasher was already switched on.
The electronic module requires a few seconds to be
ready for operation.
Wait a few seconds after opening or closing the
door.
Then touch the sensor control.
The dishwasher stops
during a programme.
The mains fuse has tripped. The display is dark and
the dishwasher cannot be switched on.
Reset the mains fuse (see data plate for minimum
protection rating).
If the mains fuse trips again, contact the Miele
Customer Service Department.
To Next Page
Loading...
