Before using for the first time
28
Activating AutoDos
The display changes to the settings
screen for AutoDos (see “Detergent –
Automatic dispensing/AutoDos”).
Even if you do not wish to use Auto-
Dos, you must remove the tag from
the AutoDos lid before running the
first programme sequence (see “De-
tergent – Activating AutoDos”).
You can activate AutoDos.
If you do not wish to use AutoDos
(automatic dispensing), you can manu-
ally dispense the detergent via the de-
tergent compartment (see “Detergent –
Manual detergent dispensing”).
Select the setting you want and con-
firm with OK.
This setting applies to all programmes
and you can change it at any time using
the AutoDos sensor control.
Finally, prompts will appear in the dis-
play.
After confirming these prompts with
OK, the messages Refill salt and
Refill rinse aid may appear.
Add salt and rinse aid if necessary
(see “Before using for the first time –
Dishwasher salt” and “Rinse aid”).
Select OK to confirm the messages.
The programme selected will appear
briefly in the display and the appropri-
ate sensor control will be illuminated.
Next, the estimated energy and water
consumption may be shown for the
chosen programme for several
seconds.
Then the display will show the estim-
ated running time for the programme
selected.
To Next Page
Loading...
