Miele G 7600 - Fault in the Autodos (Automatic Dispensing)

Problem solving guide
115
Fault in the AutoDos (automatic dispensing)
Problem Cause and remedy
The following message
will appear on the dis-
play:
Check PowerDisk
The AutoDos function is activated. There is no
PowerDisk or an empty PowerDisk has been inser-
ted.
 Confirm the message Check PowerDisk with OK.
 Insert a full PowerDisk.
 Use the sensor controls to select the Available
message and confirm with OK (see “Detergent –
Automatic dispensing/AutoDos”).
 If you do not wish to use automatic dispensing,
deactivate the function using the AutoDos
sensor control or by confirming the Not available
message with OK.
The warning buzzer is
sounding.
The programme does
not start or a pro-
gramme that has
already started stops.
The message
AutoDos lid open appears
in the display.
The lid has not been closed properly.
 Close the AutoDos lid and lock it fully (see “Deter-
gent” chapter, “Automatic dispensing/AutoDos”
section).
 If the lid cannot be fully closed, check whether the
PowerDisk holder is lying flat (see “Detergent”
chapter, “Inserting a PowerDisk” section).
 If the same fault message appears again, call
Miele Service.
The message
PowerDisk empty. Deactiv-
ate AutoDos with OK ap-
pears in the display.
The AutoDosfunction is active and the PowerDisk
is empty.
 Replace the PowerDisk (see the “Detergent”
chapter, “Automatic dispensing/AutoDos” section).
If you do not wish to use automatic dispensing,
deactivate the function using OK or the Auto-
Dossensor control.
The message
PowerDisk empty. Deactiv-
ate AutoDos with OK ap-
pears in the display
even though you have
inserted a new
PowerDisk.
The dishwasher was switched off when the
PowerDisk was replaced and it has therefore not re-
cognised the new PowerDisk.
 Switch the dishwasher on before replacing the
PowerDisk (see the “Detergent” chapter, “Auto-
matic dispensing/AutoDos”, “Inserting a
PowerDisk” section).