Settings
46
AutoOpen
In some programmes the door automat-
ically opens slightly to assist the drying
process.
This function can be deactivated if you
wish. However, this negatively affects
the drying process in most cases.
Risk of injury due to door open-
ing automatically.
The door may open automatically at
the end of the programme.
Keep the area around the door free
of obstructions.
Risk of damage due to steam.
Steam from the dishwasher could
damage delicate housing units and
the edges of worktops when you
open the door at the end of the pro-
gramme if the fan is no longer run-
ning.
If you have deactivated the auto-
matic door opening function but
would still like to open the door at
the end of the programme, then
make sure that you open the door
fully.
2nd interim rinse
You can choose this function to in-
crease the cleaning performance of the
programmes with a second interim
rinse.
When this function is activated, water
consumption may increase.
If this function is switched on, it will be
applied to all programmes until it is
switched off again (except for the ECO
programme).
Hygiene cycle
If you mainly use low temperature pro-
grammes (<50°C), there is a risk of
bacteria and unpleasant odours build-
ing up in the wash cabinet (see “Clean-
ing and care – Hygiene cycle”).
If this function is switched on, a mes-
sage will be displayed recommending
the use of a high temperature pro-
gramme after several low temperature
programmes have been run.
To Next Page
Loading...
