Miele G 7600 - Refilling Salt

Before using for the first time
31
Refilling salt
 When the refill reminder Refill salt
appears in the display, wait until the
end of the programme and then refill
the salt reservoir.
 Confirm with OK.
The salt refill indicator will go out.
 Risk of corrosion due to saline
solution.
Saline solution that runs out can
cause corrosion in the wash cabinet
and to the load items.
Immediately after filling the salt
reservoir and each time you remove
the salt reservoir cap, run the Rinse
salt programme without load items in
the dishwasher to dissolve and re-
move any traces of salt from the
wash cabinet.
After the salt reservoir has been filled,
the salt refill indicator may still appear
on the display if the salt concentration
has not yet reached the correct level. In
this case, confirm the message again
with OK.
The salt refill indicator will be switched
off if you have programmed the dish-
washer for a water hardness below
0.9mmol/l (5°dH – German scale).