Miele G 7600 - Page 116

Problem solving guide
116
Problem Cause and remedy
At the end of the pro-
gramme, the buzzer
sounds and the display
shows the following
message:
Fault F601
There is a fault in the AutoDos.
 Switch the dishwasher off and back on again.
 Check whether the PowerDisk holder and the
PowerDisk have been fitted correctly (see the “De-
tergent” chapter, “Automatic dispensing/AutoDos”
section).
 Activate the AutoDosfunction and start the pro-
gramme again.
If the fault message appears again, there is a tech-
nical fault. You can continue to use your dishwasher
by deactivating automatic dispensing using the
AutoDossensor control and manually dispensing
the detergent into the detergent compartment.
 If you wish to use automatic dispensing again,
contact Miele Service.
At the end of the pro-
gramme, the alarm tone
might sound and the
display shows the fol-
lowing message:
AutoDos maintenance re-
quired
The dishwasher does
not switch off at the end
of the programme.
The crockery may not
be clean because an in-
sufficient amount of de-
tergent was dispensed.
The AutoDos func-
tion is automatically de-
activated during the
programme sequence.
No or an empty PowerDisk has been inserted or the
AutoDos is blocked by residual detergent. Detergent
dosage is insufficient.
The AutoDos function was automatically deactiv-
ated.
 Switch the dishwasher off and back on again.
Multiple messages appear in the display.
 Clean the AutoDos (see “Detergent – Cleaning the
AutoDos”).
 Insert a full PowerDisk and close the AutoDos lid.
 Clean the lower spray arm (see “Cleaning and care
– Cleaning the spray arms”).
 Select OK to confirm each message.
 Activate the AutoDos function by confirming the
message AutoDos available using OK.
 Start the programme again.