Problem solving guide
54
Problem Possible cause and remedy
Power setting 9 is
automatically reduced if
you select power
setting 9 on two linked
cooking zones or
extended zones at the
same time.
Operating both zones at power setting 9 would
exceed the permitted maximum power for the
cooktop.
Use another cooking zone which is not linked.
The food in the pan
hardly heats up or does
not heat up at all when
the Auto heat-up
function is switched on.
There is too much food in the pan.
Start cooking at the highest power setting and
then turn down to a lower one manually later on.
The pan is not conducting heat properly.
Use a different pan which is better able to conduct
heat on an induction cooktop.
A noise can be heard
after the appliance is
switched off.
The fan will continue running until the appliance has
cooled down. It will then switch itself off
automatically.
The sensor switches
show increased
sensitivity or fail to
react.
The sensitivity level of the sensor switches has
changed.
Make sure that there is no direct light (from the sun
or from an artificial source) falling onto the
cooktop. The area surrounding the cooktop must
not be too dark.
Make sure that there is nothing covering the
sensors or the cooktop.
Take any pans off the cooktop and wipe away any
food deposits.
Interrupt the power supply to the cooktop for
approx. 1 minute.
If the problem persists after power is restored,
please contact Miele.
flashes alternately
with in the timer
display and a tone is
sounding.
The cooktop is incorrectly connected.
Disconnect the cooktop from the mains electricity
supply.
Contact Miele. The cooktop must be connected to
the mains according to the wiring diagram.
To Next Page
Loading...
