Problem solving guide
56
Problem Possible cause and remedy
The sensor is lit up. The charcoal filter needs to be reactivated.
If the extractor is being operated in Recirculation
mode, proceed as described in the operating and
installation instructions supplied with the
recirculation box. Reset the operating hours
counter (see “Cleaning and Care” in this manual).
If the extractor is being operated in Extraction
mode, reset the operating hours counter (see
“Cleaning and Care” in this manual).
The sensor is lit up. The grease filter must be cleaned.
Clean the grease filter as described in “Cleaning
and Care – Grease filter / Extraction grille”.
To Next Page
Loading...
