Special features in the programme sequence
49
Spinning
Final spin speed
When a programme is selected, the maximum spin speed for this
wash programme is shown in the display.
You can reduce the final spin speed.
However, you cannot select a final spin speed higher than that shown
in the chart.
Interim spin
There is a spin cycle after the main wash and between the rinses. A
reduction in the final spin speed will also reduce the interim spin
speed accordingly.
Omitting the final
spin (Rinse hold)
Select the Rinse hold Extra and then the Drain programme. After the
last rinse cycle, the water will be pumped away and the Anti-crease
phase will switch on.
Anti-crease
At the end of the programme, the drum continues to turn at intervals
for up to 30minutes to help prevent creasing. The door can be
opened at any time during the anti-crease phase.
There is no anti-crease phase at the end of some programmes.
To Next Page
Loading...
