Supervisor level
58
Process technology
Anti-crease
The Anti-crease function helps prevent creasing if laundry is not
going to be removed immediately after the end of the programme.
The drum continues to turn at intervals for up to 30minutes at the
end of the programme.
The door can be opened at any time during the Anti-crease phase.
Factory default: On
Service interval
Service information can appear in the display. You can configure
whether a date or the number of operating hours is displayed.
You can select up to 3 messages with your own text.
Your message is displayed at the end of the programme and can be
acknowledged with OK. The same message appears at the end of the
next programme.
Settings
This setting allows you to determine the interval (by hours or date) at
which the message appears.
- Factory default: Off
- By time
You can then select a time interval between 1–9999 hours.
- By date
You can then select a date.
Message text
Enter your individual message text for your planned maintenance
work.
Reset display
The message will appear until the display is permanently reset. The
message then only appears again when the next interval is reached.
To Next Page
Loading...
Need help?
General
