Supervisor level
53
Operation/display
Language
The display can be set to appear in one of several different
languages. You can select the permanent supervisor language via
the Language sub-menu.
When a programme is running, you can change the user language
using the sensor.
Language menu
The display can be set to one of several different user languages.
This setting allows you to determine how languages can be
selected.
International
6 languages are available. The sensor is not active. Note the
settingSet languages.
Language selection
The sensor can be used to select a language. All languages are
available (factory setting).
You can change the order of the first 4languages. These slots are
allocated to the most commonly used languages.
Standard language
The user language cannot be changed. The user language is the
same as the operator language. The sensor is not active.
Set languages
The languages for the setting Language entry International can be
changed.
6 languages can be selected. All languages are available.
If you wish to add a new language to the language menu:
First select the language you want to replace.
All available languages are displayed.
Select and confirm the language that is to replace the previous
language.
The new language will appear in place of the old one.
Display
brightness
The brightness of the display can be altered. The setting depends on
the various lighting conditions in the place of installation.
It can be set to one of 10 different levels.
To Next Page
Loading...
Need help?
General
